This works in conjunction with the setting in AlphaValue. HideOnMouseOver Default: 0Ĭontrols the transparency of the skin when the mouse is moved on and off of it. When changed using the Transparency setting in the Manage interface, a range of percentages is offered, but corresponding numeric values are stored. To have a skin be invisible but react to the mouse, a minimum setting of 1 should be used here. Note: A setting of 0 (fully transparent) will not allow detection of the mouse on the skin, and the HideOnMouseOver option will have no effect. Valid values range from 0 (fully transparent) to 255 (fully visible). The !Show bang must be used to show the skin. To disable snapping temporarily, hold the CTRL key down while moving the skin. If set to 1, the skin will snap onto screen edges and other skins when moved. If set to 1, the skin can be dragged around with the mouse. Using Stay Topmost can overcome this, but again, you must not have two skins set to Stay Topmost that overlap. Note: If another application window explicitly sets itself to "top" after a skin set to Topmost is loaded, the application window will be in front until the skin is clicked or refreshed. Overlapping skins with the same setting should use LoadOrder to control relative position. Two Rainmeter skins both set to On Desktop will not change relative to each other on click. The skin will stay visible when showing the desktop and stay behind other normal application windows. AlwaysOnTop Default: 0ĭefines the Z-position (front to back) of the skin. If set to 1, changes to the window position will be saved to Rainmeter.ini. The value is in pixels.Ī trailing % sign indicates that the value is a percentage of the config window width, rather than pixels.Ī trailing R with AnchorX will make the position relative to the right edge of the config window instead of the left.Ī trailing B with AnchorY will make the position relative to the bottom edge of the config window instead of the top.īoth AnchorX and AnchorY will accept formulas.Īs an example, by setting WindowX, WindowY, AnchorX and AnchorY all to 50% the config will be truly centered in the primary monitor regardless of screen resolution or aspect ratio. AnchorX and AnchorY allow that anchor position to be changed. The screen selection will apply to both WindowX and WindowY if the value is set on only one of AnchorX, AnchorYīy default WindowX and WindowY control the position of the upper left corner of the config window. You can override this with N where N is 0 to 32 and denotes which screen to position the skin on (1-32) or the virtual desktop (0). The formula must be enclosed in (parenthese), with any trailing % / R / B at the end, and outside the (parentheses).īy default the position is relative to the primary screen. The % and R / B modifiers can be used together.īoth WindowX and WindowY will accept formulas. The value is in pixels.Ī trailing % sign indicates that the value is a percentage of the screen width, rather than pixels.Ī trailing R with WindowX will make the position relative to the right edge of the screen instead of the left.Ī trailing B with WindowY will make the position relative to the bottom edge of the screen instead of the top. ini or variant is the file in alphabetical order in the config folder. If a number other than 0, the active skin. The skin is defined in Rainmeter.ini using the Config name. ) define options for how the skin is loaded and displayed in Rainmeter.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |